Removing The Braking System (Versions With Abs) - Husqvarna TR 650 TERRA 2013 Workshop Manual

TR 650 TERRA 2013 - TR 650 STRADA 2013
2
1
3
4
4
6
5
6
5
BRAKES

Removing the braking system (Versions with ABS)

Removing the ABS unit
Remove the tank, the rear chassis and the rear wheel as described in the rela-
tive paragraphs.
The new ABS unit is supplied pre-filled with fluid.
Brake fluid is highly corrosive and may cause skin irritation; place
absorbent paper around the ABS unit to absorb any spilled fluid.
- Drain the fluid from the front braking and rear braking systems as described
in the relative paragraphs.
1
- Disconnect the connector (1) from the ABS unit: press the tab (2) to release
the connector.
- Undo the drilled bolts (3) and disconnect the lines (4).
- Undo the screws (5) and remove the ABS unit (6).
- Fit the new ABS unit, tightening the screws (5), remove the protective caps
and reconnect the lines replacing all the seal washers and ensuring that
each line is reinstalled in exactly the same position as before.
H11860
- Reconnect the electric power connector.
- Fill the system with fluid and bleed as described in the relative paragraph.
H11861
5
H11862
L.9
Workshop Manual Ed. 09-2012