Introduction; Scanning Sequence Examples - Symbol DS6707 Product Reference Manual

Chapter 5
Chapter 5

Introduction

If desired, program the digital imager scanner to perform various functions, or activate different features. This
chapter describes imaging preference features and provides the programming bar codes for selecting these
features.
The digital imager scanner ships with the settings shown in the
page 5-2 (also see
the default values suit requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in
non-volatile memory and are preserved even when the digital imager scanner is powered down.
Most computer monitors allow scanning the bar codes directly on the screen. When
NOTE
scanning from the screen, be sure to set the document magnification to a level where the bar code
can be seen clearly, and bars and/or spaces are not merging.
If not using a USB cable, select a host type after the power-up beeps sound. (See
Chapter 7, USB Interface
necessary upon the first power-up when connected to a new host.
To return all features to default values, scan the
programming bar code menus, default values are indicated with asterisks (
*

Scanning Sequence Examples

In most cases scanning one bar code sets the parameter value. For example, to disable the decode aiming
pattern, scan the Disable Decode Aiming Pattern bar code listed under
4-12. The digital imager scanner issues a fast warble beep and the LED turns green, signifying a successful
parameter entry.
Appendix A, Standard Default Parameters
and Chapter 8, RS-232 Interface
*
Enable Decode Aiming Pattern
Indicates Default
Imaging Preferences
Imaging Preferences Parameter Defaults on
for all host device and miscellaneous defaults). If
for specific host information.) This is only
Set Default Parameter on page
Feature/Option
(02h)
Option Hex Value
for programming
via SSI command
Decode Aiming Pattern on page
Chapter 6, SSI Interface
4-4. Throughout the
*
).