Introduction - Symbol DS6707 Product Reference Manual

Chapter 8
Chapter 8

Introduction

This chapter describes how to set up the digital imager scanner with an RS-232 host. The RS-232 interface is
used to connect the digital imager scanner to point-of-sale devices, host computers, or other devices with an
available RS-232 port (e.g., com port).
If the host is not listed in
parameters to match the host.
he digital imager scanner uses TTL RS-232 signal levels, which interface with most system
T
NOTE
architectures. For system architectures requiring RS-232C signal levels, Symbol offers different
cables providing TTL-to-RS-232C conversion. Contact the Symbol Support Center for more
information.
Throughout the programming bar code menus, default values are indicated with asterisks (
Most computer monitors allow scanning the bar codes directly on the screen. When
NOTE
scanning from the screen, be sure to set the document magnification to a level where the bar code
can be seen clearly, and bars and/or spaces are not merging.
Table 8-2, refer to the documentation for the host device to set communication
*
*
Baud Rate 57,600
Indicates Default
RS-232 Interface
*
).
Feature/Option