Introduction; Chapter 4: User Preferences & Miscellaneous Digital Imager Scanner Options - Symbol DS6707 Product Reference Manual

Chapter 4
Chapter 4
User Preferences & Miscellaneous Digital Imager Scanner Options

Introduction

If desired, program the digital imager scanner to perform various functions, or activate different features. This
chapter describes each user preference feature and provides the programming bar codes necessary for
selecting these features.
The digital imager scanner ships with the settings shown in the
Standard Default Parameters
requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in
non-volatile memory and are preserved even when the digital imager scanner is powered down.
Most computer monitors allow scanning the bar codes directly on the screen. When
NOTE
scanning from the screen, be sure to set the document magnification to a level where the bar code
can be seen clearly, and bars and/or spaces are not merging.
If not using a USB cable, select a host type after the power-up beeps sound. (See
Chapter 7, USB Interface
necessary upon the first power-up when connected to a new host.
To return all features to default values, scan the
programming bar code menus, default values are indicated with asterisks (
User Preferences & Miscellaneous Digital
for all host device and miscellaneous defaults). If the default values suit
and Chapter 8, RS-232 Interface
Set Default Parameter on page
*
*
High Volume
Indicates Default
Imager Scanner Options
Table 4-4 on page 4-2
for specific host information.) This is only
*
).
Feature/Option
(00h)
Option Hex Value for
programming via SSI
command
(also see Appendix A,
Chapter 6, SSI Interface
4-4. Throughout the