Symbol Spectrum24 AP-4131 Product Reference Manual page 75

3. To enable or disable interfaces on the AP , modify the following
4. Verify the values set reflect the network environment.
5. Select
6. Select
7. The system prompts
8. Select
AP-4131 Access Point Product Reference Guide
parameters:
Ethernet
Interface
RF Interface
Default Interface Specifies the default interface (
Change as needed.
or to register settings by writing changes to NVM.
Selecting displays a confirmation prompt.
information to all APs with the same Net_ID (ESS).
This option saves the configuration changes for the current AP , sends two
WNMP messages to all other APs on the Known APs table to update their
configuration and resets after the configuration has been modified.
Users can perform this option only among the same hardware platforms
and firmware version.
Type .
return to the previous menu.
Enables or disables wired Ethernet.
The default value is On.
Enables or disables radio. The default value is On.
) that the AP forwards a frame to if the AP
cannot find the address in its forwarding database.
The default interface is Ethernet. The AP defaults to
when
or press to save the System Configuration
to disregard any changes made to this screen and
Configuring the AP
,
is selected.
or
65