Kidde VM-1 User Manual page 6

VM-1 FCC compliance
This equipment can generate and radiate radio frequency energy. If the
equipment is not installed in accordance with this guide, it may cause
interference to radio communications. This equipment has been tested and found
to comply with the limits for Class A computing devices pursuant to Subpart B of
Part 15 of the FCC Rules. These rules are designed to provide reasonable
protection against such interference when this equipment is operated in a
commercial environment. Operation of this equipment is likely to cause
interference, in which case the user, at his own expense, will be required to take
whatever measures may be required to correct the interference.
VM-DACT FCC compliance
Cautions
• To ensure proper operation, this dialer must be installed according to the
enclosed installation instructions. To verify that the dialer is operating properly
and can successfully report an alarm, it must be tested immediately after
installation, and periodically thereafter, according to the enclosed test
instructions.
• In order for the dialer to be able to seize the phone line to report an alarm or
other event when other customer equipment (telephone, answering system,
computer modem, etc.) connected to the same line is in use, the dialer must
be connected to a properly installed RJ-31X jack. The RJ-31X jack must be
connected in series with, and ahead of, all other equipment attached to the
same phone line. Series installation of an RJ-31X jack is depicted in the
wiring diagram. If you have any questions concerning these instructions, you
should consult your telephone company or a qualified installer.
Testing
When programming emergency numbers or making test calls to emergency
numbers, remain on the line and briefly explain to the dispatcher the reason for
the call. Perform programming and testing activities in the off-peak hours, such
as early morning or late evenings.
Compliance
• For equipment approved before July 23, 2001:
Part 68 of the FCC rules. A label attached to the dialer contains, among other
information, the FCC registration number and ringer equivalence number
(REN) for this equipment. If requested, this information must be provided to
the telephone company.
iv
This dialer complies with
VM-1 User Guide