Kidde VM-1 User Manual page 26

Chapter 1: Introduction
Item Control/Indicator
3 Down button
4 Enter button
5 Lamp Test button
and LED
6 Drill button and
LED [1]
7 Signal Silence
button and LED [1]
8 Reset button and
LED [1]
9 ACK/Silence button
and LED
10 Controls Enabled
LED
11 Trouble LED
12 Ground Fault LED
13 Supervisory LED
14 Fire Alarm LED
15 Power LED
[1] Control and indicator is not on the RLCD or K-RLCD remote annunciator.
16
Description
Pressing the Down button scrolls down through the messages in
the event message queue and scrolls down through characters for
password entry.
Pressing the Enter button displays message details for the current
message and enters the password character selected.
Pressing the Lamp Test button turns on all LEDs and displays a
test pattern on the LCD. The LED indicates the lamp test is
running.
Pressing the Drill button turns on all audible and common alarm
output devices and, if configured, all visible devices. Pressing the
button again turns them off. The LED indicates the function is
active. Requires a password to operate.
Pressing the Signal Silence button turns off all active audible and
common alarm output devices and, if configured, all visible
devices. Pressing the button again turns them back on. The LED
indicates the function is active. Requires a password or the enable
controls key to operate.
Pressing the Reset button restores the system to the normal state.
The LED indicates the reset function is active. Requires a
password or the enable controls key to operate.
Pressing the ACK/Silence button silences the panel buzzer and
acknowledges all current events. The LED indicates the function is
active. Requires a password or the enable controls key.
Blue LED indicates the controls in that group are enabled at the
annunciator. Requires a password or the enable controls key.
Yellow LED indicates an active trouble state.
Yellow LED indicates a ground fault.
Yellow LED indicates an active supervisory state.
Red LED indicates an active fire alarm state.
Green LED indicates the annunciator is energized.
VM-1 User Guide