Safety Instructions And Warnings - NETGEAR GS418TPP Hardware Installation Manual

Easy-Mount 16-Port Gigabit High Power PoE+ Smart Managed Pro Switch with 2 SFP Ports (240W)
- IEEE 802.1x RADIUS Network Access Control
-
IEEE 802.3az Energy Efficient Ethernet (EEE)
• AutoSensing and autonegotiating capabilities for all ports.
• Auto Uplink™ technology is supported on all ports.
• Automatic address learning function to build the packet-forwarding information
table. The table contains up to 16K Media Access Control (MAC) addresses.
• Store-and-forward transmission to remove bad packets from the network.
• Full-duplex IEEE 802.3x pause frame flow control.
• Active flow control to minimize packet loss and frame drops.
• Half-duplex backpressure control.
• Per-port status LEDs and system status LEDs.
• NETGEAR green power-saving features:
- Energy efficiency mode that fully conforms to the IEEE802.3az standard
- Per-port automatic change to a lower power mode when the port link is down

Safety instructions and warnings

Use the following safety guidelines to ensure your own personal safety and to help
protect your system from potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment,
observe the following precautions:
• This product is designed for indoor use only in a temperature-controlled and
humidity-controlled environment. For more information, see the environmental
specifications in the appendix or the data sheet.
Any device that is located outdoors and connected to this product must be properly
grounded and surge protected.
Failure to follow these guidelines can result in damage to your NETGEAR product,
which might not be covered by NETGEAR's warranty, to the extent permissible by
applicable law.
Introduction
Model GS418TPP
8 Hardware Installation Guide