3. Push the sides of the bezel into place.
4. Using a Phillips screwdriver, tighten the two screws to secure the bezel to the
Replacing the 8010co chassis bottom bezel model 321325-
A
Use the procedure in this section to replace the bottom front bezel for model 321325-A.
Procedure steps
Important:
The 8005DC power supplies require a modified air intake bezel. If you have installed Model
8005DC power supplies (1500 W) in the 8010co chassis and have air intake bezel imprinted
with 312096-A, or if you have difficulty installing the bezel over the 8005DC power supplies,
you can order modified bezel model 321325-A (Order Code DS1411027).
1. Insert the three bottom bezel tabs behind the return flange on the power module.
Installation — DC Power Supply
chassis.
See figure below.
Replacing the 8010co chassis bottom bezel model 321325-A
September 2012
51