Atv Set Result Code Format Mode; Atx Set Connect Result Code Format And Call Monitoring - Siemens TC37 Module At Command Reference

AT Command Set

2.31 ATV Set result code format mode

Write command Response
ATV[<value>] This parameter setting determines the contents of the header and trailer
transmitted with result codes and information responses.
When <value> =0
0
When <value > =1
OK
Parameter
<value>
Reference Note
V.25ter In case of using the command without parameter <value> will be set to 0.
Information responses described in chapter 7 (verbose code and numeric code).

2.32 ATX Set CONNECT result code format and call monitoring

Write command Response
ATX[<value>] This parameter setting determines whether or not the TA detects the presence of
dial tone and busy signal and whether or not TA transmits particular result codes.
OK
Parameter
<value>
Reference Note
V.25ter Related <text> see chapter 7.1.4.
TC3X_ATC_01_V04.00
0 Information response: <text><CR><LF>
Short result code format: <numeric code><CR>
1 Information response: <CR><LF><text><CR><LF>
Long result code format: <CR><LF><verbose code><CR><LF>
0 CONNECT result code only returned, dial tone and busy
detection are both disabled
1 CONNECT<text> result code only returned, dial tone and busy
detection are both disabled
2 CONNECT<text> result code returned, dial tone detection is
enabled, busy detection is disabled
3 CONNECT<text> result code returned, dial tone detection is
disabled, busy detection is enabled
4 CONNECT<text> result code returned, dial tone and busy
detection are both enabled
Page 32 of 204 29.05.2002