AT Command Set
Example 3
To change the "PS" lock password, using the correct old password:
AT+CPWD=PS,1111,2222
To specify a new "PS" lock password, after the old password was disabled, e.g.
after three failed attempts to enter the password (only if Master Phone Code is
availbale):
AT+CPWD=PS,12345678,1111 (where 12345678 is the Master Phone code
Alternatively, whithout giving a new password:
AT+CPWD=PS,12345678
4.35 AT+CR Service reporting control
Test command
Response
+CR: (list of supported <mode> s) OK
AT+CR=?
Parameter
See write command
Read command
Response
+CR: <mode> OK
AT+CR?
Parameter
See write command
Write command
Response
Configures the TA whether or not to transmit an intermediate result code +CR:
AT+CR=<mode>
<serv> to TE when a call is being set up.
OK
Parameter
<mode> 0 disable
Intermediate result code
If enabled, an intermediate result code is transmitted at the point during
connect negotiation when the TA has determined the speed and quality of
service to be used, before any error control or data compression reports are
transmitted, and before any final result code (e.g. CONNECT) appears.
+CR:<serv >
Parameter
<serv>
Reference
Note
GSM 07.07
The PLMN influences the second air interface (to the terminator), therefore
another mode may be established from the network
TC3X_ATC_01_V04.00
1 enable
REL ASYNC
asynchronous non-transparent
Page 106 of 204
(where 1111 = old "PS" password and 2222 =
new password)
and 1111 is the new password. You may also
use <newpwd> to restore the former disabled
password). This operation deactivates the
present phone lock and sets a new one. See
also Chapter 4.31.1.
Deactivates the present phone lock.
29.05.2002