AT Command Set
2.21 ATS2 Escape code sequence
Read command
Response
ATS2?
S2 determines the decimal value of the ASCII character used in the escape code
sequence, which serves, during a data call, to change from data to command
mode. Compare Chapter 2.2.
The default value 043 is equivalent to an ASCII "+". Please note that the value
cannot be changed, and therefore, test or write commands are not supported.
Reference
Note
V.25ter
2.22 ATS3 Write command line termination character
Read command
Response
ATS3?
<n> OK
This parameter setting determines the character recognized by TA to terminate
Write command
an incoming command line.
ATS3=<n>
Response
OK
Parameter
<n>
Reference
Note
V.25ter
2.23 ATS4 Set response formatting character
Read command
Response
ATS4?
<n> OK
Write command
This parameter setting determines the character generated by the TA for result
ATS4=<n>
code and information text.
Response
OK
Parameter
<n>
Reference
Note
V.25ter
TC3X_ATC_01_V04.00
000-013-127
command line termination character
000-010-127
response formatting character.
Page 28 of 204
29.05.2002