Table of Contents
Advertisement
Saving parameter signal
REC
Total reset signal
RST
Memory reset
RSE
Memory
ESG
carried out
End of alarm (in
FAL
memory)
Maximum
TOP
complementary
pump
ON
Complementary
pump on
STB
Complementary
pump on standby
6.3 ALARM TABLE
MESS
DISPLAY
No water alarm -
temporary
A01
No water alarm -
A02
definitive
Pressure
A03
transducer alarm
46
The board has been reset. The cause of this signal can be a either
prolonged absence of power or if the reset button has been pressed
manually. The module will save all the information recorded, with the
exception of clock setting.
The eeprom memory has been reset (see chapter 7.2). The module
returns to the factory settings
reset
Confirms that the eeprom memory has been reset (see chapter 7.2).
Indicates the end of an alarm.
power
The complementary pump is on at the maximum frequency possible.
The complementary pump is on and regulating.
The complementary pump is on standby.
DESCRIPTION
Error due to the temporary
absence of water. This occurs
when water is absent and the
restart mechanism has been
activated. The will wait before
restarting in order to attempt to
automatically reset the error.
This condition occurs when there
is no water and the automatic
restart system has not activated
or
restart
attempts
already without managing to reset
the system functioning.
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.)
This signal occurs when the
control board cannot identify the
transducer pressure signal.
Page 19 of 30
19 - GB -
Check the water level in the first
tank or the aqueduct pressure.
Wait for the programmed
attempted restart or press the
button START/STOP for a manual
restart.
occurred
Check the water level in the first
tank or the aqueduct pressure.
Press the button START/STOP to
manually restart the system.
Check the pressure transducer is
correctly connected.
If the error occurs again, contact
your nearest assistance centre.
ACTION
Advertisement
Table of Contents
