Display Assembly - HP Pavilion Gaming 15 Series Maintenance And Service Manual

Display assembly

NOTE: The display assembly is available as a spare part only at the subcomponent level.
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Disconnect the battery (see
Remove the display assembly:
1. Open the display and position it hanging down off side of a table (1).
2. Disconnect the antenna cables from the WLAN module (2), and then remove the antenna cables from
the tape that secure them to the heat sink (3).
3. Disconnect the display cable from the system board ZIF connector (4), and then remove the display
cable from its routing path around the fan and hard drive (5).
4. Remove the three Phillips M2.5 × 5.0 screws (1) from each hinge.
(Preparation for disassembly on page
Bottom cover on page
Battery on page 37).
27).
28).
Component replacement procedures 49