Removing The Ocp Module; Preliminary Steps - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.2

Removing the OCP module

Upgrade and Repair Unit
(URU)
Tool: Phillips PH1 / (+) No. 1 screw driver
9.4.2.1

Preliminary steps

"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
"Getting access to the component" on page 58
Ê
Ê If applicable, remove the riser module 1, see section
modules" on page
9.4.2.2 Removing the OCP module
Figure 162: Removing the OCP module
Ê Remove the four screws (1).
I
When replacing an OCP module: keep the screws for installing the
new OCP module.
Ê Remove the OCP module (2).
250
71.
Upgrade and Maintenance Manual
Hardware: 5 minutes
"Handling riser
RX2540 M4