Engine Replacement; Removal - Graco LineLazer V 250SPS Repair Parts

Engine Replacement

Removal

1. Remove clutch, see Clutch Replacement, page 24.
NOTICE
To reduce the risk of battery damage and shorts,
always disconnect NEGATIVE (black wire) first.
2. Disconnect two negative (black) battery wires at bat-
tery. Negative battery post is located above platform
on the left side.
3. Disconnect seven wires from engine.
Engine Ground
Ignition
Voltage Regulator
Starter Solenoid
Battery
4. Remove air filter cover, element and base.
ti19186a
3A3394E Repair - Parts
5. Disconnect throttle cable.
6. Disconnect choke cable.
7. Remove four mounting bolts from engine.
ti23921
8. Remove engine. NOTE: Engine voltage regulator is
located below engine mounting plate. Remove two
screws and disconnect wires.
Engine Replacement
ti19183a
ti19185a
ti19187a
ti19703a
27