Filters - Mira Discovery Installation And User Manual

Filters - Exposed Models
To clean or replace the inlet filters:
1. Isolate the hot and cold water supplies.
2. Operate the Flow Lever to drain any
residual water.
3. Remove the Elbow Shrouds.
4. Unscrew the Filter Caps with the 'O' key
(supplied) or a 12 mm hexagonal key.
5. Remove the Elbow Retaining Clips.
6. Carefully pull out the Inlet Filters.
7. Clean each filter in turn under a jet of water to remove any lodged particles.
8. Refit the Inlet Filters.
9. Refit the Elbow Retaining Clips and tighten the Filter Caps.
Caution! Make sure that the Elbow Retaining Clips are fitted vertically as
illustrated, otherwise the Elbow Shrouds will not fit correctly.
10. Restore the hot and cold water supplies and check for leaks.
11. Refit the Elbow Shrouds.
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.co.uk 0844 556 1818
Inlet Filter
Elbow Retaining Clip
Elbow Retaining Clip
32
'O' Key
'O' Seal
Filter Cap