Preparation; Charging The Battery - Denso BHT-1400-CE Series Hardware User Manual

BHT-1400-CE Series

2.1 Preparation

Follow the steps below to prepare the BHT.

2.2 Charging the Battery

(Page 10)
2.3 Attaching the Hand Strap
(Page 17)
2.4 Initial Setup
(Page 19)
2.2 Charging the Battery
The battery cartridge is not charged when purchased.
Charge the battery before using.
To charge the battery, use only the CU (CU-AU1-14/CU-AR1-14/CU-AL1-14).
The charging time is approximately 3 hours.
• If the power is supplied via the CU-AU1-14 from the device connected to the USB port, charging takes
approximately 12 hours.
• A slightly discharged battery takes less time to fully charge.
Charging Precautions
● Do not touch the BHT, battery or charger terminals by hand or stain them.
Failure to follow instruction may result in a contact failure or a charging error.
● Never charge the battery near fire or in a high-temperature environment.
High-temperatures may activate the charger protection device to stop charging, or lead to protection device
damage, overheating, explosion or fire.
● Stop charging if the charge does not complete after the specified time has elapsed.
● Use only the dedicated battery specified by DENSO WAVE.
10
Charge the battery.
Attach the hand strap to prevent the BHT from being
dropped.
Calibrate the touch screen and set the calendar clock
when the power is turned ON for the first time.