Bht Preparation" Procedure; Loading And Charging The Battery Cartridge - Denso BHT-1361QWB-CE Hardware User Manual

BHT-1300-CE Series

2.1 "BHT Preparation" Procedure

Follow the steps below to prepare the BHT
2.2 Loading and Charging the Battery
Cartridge (Page 10)
2.3 Att aching the Hand Strap
(Page 18)
2.4 Initial Setup
(Page 20)

2.2 Loading and Charging the Battery Cartridge

The battery cartridge is not charged when purchased and should therefore be charged prior to use.
The chargers that can be used with the BHT are the communication units (CU-1321) and battery chargers (CH-201A*,
CH-1104* and CH-1354).
* The CH-201A and CH-1104 chargers are used for charging individual batteries.
The charging tim e is approximately 3.5 hours to charge the BT-20LB and 2.5 hours to charge the BT-130LA.
 If the power is supplied via the CU-1321 from the device
10 hours for the BT-20LB and 6 hours for the BT-130LA.
 An only slightly discharged battery cartridge should take less time to becom
Charging Precautions
 Do not touch the BHT, battery, or charger terminals by hand or stain them. Doing so could result in a contact
failure or prevent charging.
 Never charge the battery near fire or in a high-temperature environment.
High-temperatures may activate the charger's protective device and charging will become impossible. This may
lead to damage in the protective device and overheating, blowout or combustion of the charger.
 Terminate charging if not completed even after the specified time has elapsed.
 Do not use battery cartridges other than that specified by DENSO WAVE.
10
for use.
First load and charge the battery cartridge.
Attach the hand strap to prevent the BHT from being
dropped.
Calibrate the touch screen and set the calendar clock
when the power is turned O
connected to the USB port, charging takes approximately
N for the first time.
e fully charged.