Denso BHT-1400-CE Series Hardware User Manual page 52

Barcode/2d code handy terminal
Table of Contents

Advertisement

4.
Insert the catch tab into the fit position
(1) then replace the cover (2), and then
slide shut the cover lock (3).
Battery Recycling Request
● This product uses a lithium-ion battery that contains recyclable rare earth metals. Please recycle the battery
correctly to promote sustainable reuse of these resources.
● Used batteries must not be disposed of as combustibles.
● Contact your nearest rechargeable battery recycling center or sales office for information on disposal
procedures.
● When disposing used batteries, cover the terminals with vinyl tape to insulate and protect them from
overheating or fire due to a short-circuit.
● Never disassemble batteries.
Failure to follow all instructions listed below may cause overheating, smoking, fire, or an
explosion.
Never charge the battery cartridge near fire or under a scorching sun.
Always use a dedicated charger to charge the battery cartridge.
Failure to follow the instruction below may cause overheating, smoking, fire, or an explosion.
Stop charging if the charge does not complete after the specified time has elapsed.
Replace the battery in a prompt manner.
− Note −
If the BHT is left for a long period of time with the battery removed, all data including files and
settings stored in the RAM may be lost and the RAM will restore to the factory default. Any
important data should be backed up to the "FLASH" folder or to the computer. The BHT starts
from the "Initial Setup" when the BHT turns ON after the data in the RAM is deleted.
Always turn the BHT power OFF before replacing the battery. Replace the battery with a new
one within three minutes of removal to avoid data loss. Turn ON the BHT power to check
proper operation of the BHT after replacement.
Use the CU to charge battery. Refer to "Chapter 2.2" for details on charging.
"Replace the battery!" or "Charge the battery!" message may appear when the BHT is subject
to impact. The battery may not have run out, reboot the BHT and check the battery voltage
level.
The rechargeable battery may swell depending on usage or environmental conditions, as the
battery reaches the end of its life.
Barcode/2D Code Handy Terminal
The crossed-out wheeled bin is applicable
for EU member status only.
43

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bht-1400bwb-ceBht-1400qwb-ce

Table of Contents