Denso BHT-1400-CE Series Hardware User Manual page 7

Barcode/2d code handy terminal
Table of Contents

Advertisement

Handling the battery
Failure to follow all instructions listed below may cause electrical shock, overheating, smoking, fire, or an
explosion.
• Do not disassemble or modify the battery.
• Do not connect the battery (+) and (-) terminals with a metal object such as a wire.
• Do not carry or store the battery together with metallic ball-point pens, necklaces, coins, hairpins, etc.
• Do not use or store the battery in places exceeding the service or storage temperature.
• Do not expose the battery to fire or heat.
• Do not use or leave the battery near high-temperature locations (50 °C or higher) such as a fire or heater.
• Do not put or wet the battery with any liquid.
• Do not charge the battery near a fire or in direct sunlight.
Failure to follow this instruction may lead to liquid spill, blowout or combustion due to the increased
temperature in the battery.
• Do not charge the rechargeable battery where any inflammable gases may be emitted
• Do not hammer nails into the battery, hit it with a hammer, or step on it.
• Do not subject the battery to strong impact or throw it.
• Do not use a damaged or deformed battery.
• Do not solder directly to the battery.
• During use, charging, or storage of the battery, if any odor comes from the battery or it is overheated,
discolored, deformed, or anything unusual is noticed, remove the battery from the BHT or charger. Do
not use the battery.
• If any battery fluid leaks out from the battery and gets into your eyes or comes into contact with the skin,
wash thoroughly with clean water such as tap water without rubbing, and seek medical attention
immediately. Failure to follow instruction may result in eye or skin injuries.
Barcode/2D Code Handy Terminal
vi

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bht-1400bwb-ceBht-1400qwb-ce

Table of Contents