Rear Connector Panel - Panasonic AW-RP655N Operating Instructions Manual

Parts and their functions

$ Rear Connector Panel

c GND terminal
Use to ground the unit.
d DC12V IN terminal
Connects the AW-PS505A AC adapter (sold separately).
e TALLY/INCOM terminal
Connect this to the TALLY/INCOM connector on the
video switcher or other units.
When the TALLY connector is set to the GND level, the
TALLY lamp (_) lights. Do not apply a voltage in excess
of 5V to this connector.
Pin layout as seen from the
back panel of AW-RP655
Connect a 4-wire INCOM system to the INCOM
connector.
Pin No. Signal Name
1 TALLY1
9 TALLY2
2 TALLY3
10 TALLY4
3 TALLY5
11 TALLY GND
4 – – –
12 – – –
5 – – –
13 – – –
6 MIC +
14 MIC –
7 INCOM GND
15 SP –
8 SP +
h g f e
f REMOTE/SERVICE connector
A personal computer or other external equipment is
connected here when a pan/tilt head system is to be
controlled by these equipments.
1
6
g REMOTE/SERVICE switch
Function selection switch for the REMOTE/SERVICE
terminal. Set the switch in the N position during use.
h TO CONTROL PANEL IN terminal
TO CONTROL PANEL OUT terminal
Connects AW-RP655 (control panel) set to PANEL
MODE.
Connect the IN terminal of this unit to the OUT terminal of
the control panel, or the OUT terminal of this unit to the
IN terminal of the control panel.
12
d c
Pin No. Signal Name
5
1 – – –
9
2 RXD IN
3 TXD OUT
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 – – –