Panasonic AW-RP655N Operating Instructions Manual page 13

Parts and their functions
i TERMINATION switch
Termination switch for the control signal communicating
with the control panel.
• Set this switch to "2" when there are no control panels
connected to this unit.
• Set this switch and the control panel TERMINATION
switch to "1" when there is 1 control panel connected to
this unit.
• Set the TERMINATION switches on the equipment on
both sides of the connection to "1" when 2 control
panels are connected to this unit and set the
TERMINATION switches of devices in the middle of the
connection to "OFF."
j ID switch
Switch to set the operating mode for this unit.
MAIN:
Operates in Main Mode.
1/2:
Operates in Panel Mode.
In the case of a system with 2 connected control panels,
set each control panel setting to a different value.
k j i
k TO PAN/TILT HEAD 1/EXT terminal
• Functions as the pan/tilt head's connection terminal
when the EXT CONTROL OUT is set to OFF on the
controller setting menu (see page 36).
Connect a 10BASE-T straight cable (UTP category 5) to
the pan/tilt head's IP/RP terminal.
May be extended up to a maximum of 1000 m.
Use the RS-232C/RS-422 converter and connect to
pan/tilt head's RS-232C control terminal when
connecting to the AW-PH300, AW-PH300A, AW-PH500
or AW-PH600.
• Functions as the AW-DU600 dial up adapter's connection
terminal when the EXT CONTROL OUT is set to ON on
the controller setting menu (see page 36).
Connect a 10BASE-T straight cable (UTP category 5) to
the AW-DU600's PAN/TILT CONTROL IN terminal. May
be extended up to a maximum of 1000 m.
For more details, refer to the operating instructions of
the dial up adapter. Use the following terms instead:
• AW-RP605 r AW-RP655
• EXTERNAL CONTROL OUT terminal
• There are no software version restrictions for this unit
in systems with dial up adapters.
13
r TO PAN/TILT HEAD 1/EXT terminal