MARUTI SUZUKI Celerio Tour H2 Owner's Manual page 90

OTHER CONTROLS AND EQUIPMENT
Defrost (e)
EXAMPLE
Temperature-controlled air comes out of
the windshield defroster outlets, the side
defroster outlets and the side outlets.
Air intake selector (4)
EXAMPLE
(g)
This selector is used to select the following
modes.
Fresh Air (f)
When this mode is selected by moving the
lever to right, outside air is used.
5-11
Recirculated Air (g)
When this mode is selected by moving the
lever to left, outside air is shut out and
inside air is recirculated. This mode is suit-
able when driving through dusty or polluted
air such as in a tunnel, or when attempting
to quickly cool down the interior.
NOTE:
If you select "RECIRCULATED AIR" for an
extended period of time, the air in the vehi-
76MH0A088
cle can become contaminated. Therefore,
you should occasionally select "FRESH
AIR".
Air conditioning switch (5)
To turn on the air conditioning system, set
the blower speed selector to a position
other than "OFF" and push in the "A/C"
(f)
switch. With this "A/C" switch operation, a
indicator light will come on when the air
conditioning system is on. To turn off the
air conditioning system, push the "A/C"
switch again.
During operation of the air conditioner, you
76MH0A089
may notice slight changes in engine
speed. These changes are normal, the
system is designed so that the compressor
turns on or off to maintain the desired tem-
perature.
Less operation of the compressor results
in better fuel economy.
System Operating Instructions
Natural ventilation
Select "VENTILATION" and "FRESH AIR",
the temperature selector to the desired
temperature position, and the blower
speed selector to "OFF". Fresh air will flow
through the vehicle during driving.
Forced ventilation
The control settings are the same as for
natural ventilation except you set the
blower speed selector to a position other
than "OFF".
Normal heating (using outside air)
Select "HEAT" and "FRESH AIR", the tem-
perature selector to the desired tempera-
ture position and the blower speed selector
to the desired blower speed position. Set-
ting the blower speed selector to a higher
blower speed position increases heating
efficiency.
Quick heating (using recirculated air)
The control settings are the same as for
normal heating except you select "RECIR-
CULATED AIR". If you use this heating
method for an extended period of time, the
air in the vehicle can become contami-
nated and the windows can become misty.
Therefore, use this method only for quick
heating and change to the normal heating
method as soon as possible.