Driving On Slippery Roads - MARUTI SUZUKI Celerio Tour H2 Owner's Manual

Table of Contents

Advertisement

While moving uphill/gradient from a
stand still condition
• Apply the parking brake firmly so that the
vehicle does not roll backwards.
• Depress the Clutch pedal and Shift the
gearshift lever to 1
Select position.
st
• Do not slip the clutch.
• When ready to start, press accelerator
pedal and slowly release the clutch
pedal simultaneously. When the vehicle
starts to move, gradually release the
parking brake.
WARNING
Do not hold the brake pedal down too
long or too often while going down a
steep or long hill. This could cause
the brakes to overheat, resulting in
reduced braking efficiency. Failure to
take this precaution could result in
loss of vehicle control.
NOTICE
When descending a downhill, Never
turn the ignition key to "LOCK" posi-
tion. Emission control system dam-
age may result.

Driving on slippery roads

EXAMPLE
On wet roads, you should drive at a lower
speed than you do on dry roads due to
possible slippage of tires during braking.
When driving on icy, snow-covered or
muddy roads, reduce your speed and
avoid sudden acceleration, abrupt braking,
or sharp steering movements.
Tire chains
Tire chains should only be used if they are
needed to increase traction or are required
by law. Check that the chains you use are
the correct size for your vehicle's tires.
Also check that there is enough clearance
between the fenders and the chains as
installed on the tires.
Install the chains on the front tires tightly,
according to the chain manufacturer's
instructions. Retighten the chains after
driving about 1.0 km if necessary. With the
chains installed, drive slowly.
• If you hear the chains hitting
against the vehicle body while driv-
ing, stop and tighten them.
• If your vehicle is equipped with full
wheel caps, remove the wheel caps
before installing the chains or the
wheel caps can be damaged by the
chain bands.
Stuck vehicle
If your vehicle gets stuck in snow, mud or
76MM04002
sand, follow the directions below:
1) Shift the transaxle back and forth
between the first gear and reverse. This
will create a rocking motion which may
give you enough momentum to free the
vehicle. Press gently on the accelerator
to keep wheel spinning to a minimum
wheel rpm. Remove your foot from the
accelerator while shifting.
Do not race the engine. Excessive
wheel spin will cause the tires to dig
deeper, making it more difficult to free
the vehicle.
2) If your vehicle remains stuck after a few
minutes of rocking, we recommend you
to consult your authorised Maruti
Suzuki workshop or a roadside assis-
tance service. If a towing service is not
available in an emergency, your vehicle
may be temporarily towed by a towing
NOTICE
4-4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents