Windshield Wiper And Washer Lever - MARUTI SUZUKI Celerio Tour H2 Owner's Manual

BEFORE DRIVING
Windshield Wiper and Washer
Lever
EXAMPLE
WARNING
To avoid possible injury, do not oper-
ate controls by reaching through the
steering wheel.
Wiper and Washer Operation
When the ignition switch is in the "ON"
position, you can use the wiper/washer
lever or switch (if equipped).
2-37
Windshield Wipers
EXAMPLE
To turn the windshield wipers on, move the
65D611S lever down to one of the three operating
positions. In the "INT" position, the wipers
operate intermittently. The "INT" position is
very convenient for driving in mist or light
rain. In the "LO" position, the wipers oper-
ate at a steady low speed. In the "HI" posi-
tion, the wipers operate at a steady high
speed. To turn off the wipers, move the
lever back to the "OFF" position.
Move the lever up and hold it to the "MIST"
position, the windshield wipers will turn on
continuously at low speed.
Windshield Washer
EXAMPLE
To spray windshield washer fluid, pull the
lever toward you. The windshield wipers
will automatically turn on at low speed if
they are not already on and the "INT" posi-
76MM02016
tion is equipped.
• To prevent windshield icing in cold
weather, turn on the defroster to
heat the windshield before and
during windshield washer use.
• Do not use radiator antifreeze in
the windshield washer reservoir. It
can severely impair visibility when
sprayed on the windshield, and can
also damage your vehicle's paint.
76MM02017
WARNING