Siemens FS720 Mounting & Installation page 94

Installing, exchanging and connecting modules
6
Fire brigade periphery module [DE]
94 | 222
Building Technologies
Fire Safety
Figure 44: Mounting of the fire brigade periphery module
1 Spacer sleeves (5 pieces) (only required for mounting on the mounting
plate)
2 3 fixing screws at top
3 Fire brigade periphery module
4 2 fixing screws at bottom
X2 Connection for fire brigade operating panel
X3 Connection for fire brigade operating panel
X4 Connection for remote transmission / release element
X5 Connection for fire brigade key depot
X6 Connection for intrusion detection system, local alarm, identification lamp
X401 Connection for periphery bus
X402 Connection for periphery bus
Mounting steps
1. Mount the fire brigade periphery module (3) to the mounting plate or the rear
panel (observe correct installation position) as shown in the figure using the
fixing screws (2 and 4). Spacer sleeves (1) must be used when installing on the
mounting plate.
2. Wire up the fire brigade periphery module according to the pin assignment.
X5
X4
X3
X2
X402
X401
1
X6
2
3
4
A6V10210390_j_en_--
2015-12-15