Periphery Board (4 Loops); Installation - Siemens FS720 Mounting & Installation

6.3 Periphery board (4 loops)

6.3.1 Installation

X400
X401
1
Building Technologies
Fire Safety
The periphery board (4-loop) FCI2004-A1 is already mounted in the fire control
panels in the factory and only has to be replaced in the event of a repair.
Prerequisites
● Components that make access to the periphery board difficult are removed
(e.g. mounting plate).
● All connections and plug connectors are disconnected (label cables before
disconnecting them).
● The periphery board is removed.
X5
X7
X22
X6
X8
X3 X1
Figure 25: Mounting of the periphery board (4 loops)
1 Threaded bolts on rear panel
2 13 fixing screws
3 Periphery board (4 loops)
X3 Connector for connection cable to PMI & mainboard (operating unit)
X400 Connector for the periphery bus to the fire brigade periphery module [DE]
X401 Connector for periphery bus
Installing, exchanging and connecting modules
X11
X21
X12
2 3
Periphery board (4 loops)
A6V10210390_j_en_--
2015-12-15
6
55 | 222