Network Module (Safedlink); Installation - Siemens FS720 Mounting & Installation

Installing, exchanging and connecting modules
6

Network module (SAFEDLINK)

6.12 Network module (SAFEDLINK)

6.12.1 Installation

100 | 222
Building Technologies
Fire Safety
This component is installed in exactly the same way as for the operating units
with the PMI & mainboard FCM2004 and the PMI & mainboard FCM2027.
If you are installing only one network module (SAFEDLINK) FN2001-A1, you must
do so in the left-hand slot (X13).
When two network modules are used (SAFEDLINK) FN2001-A1, installation is
identical for both.
5
4
3
2
X13
Figure 45: Installation of both network modules (SAFEDLINK)
1 Network module (SAFEDLINK) on X13 (master module)
2 Fixing screws (2 pieces)
3 Mounting links on support plate
4 Nut for cable gland (2 per module)
5 Cable gland (2 per module)
6 Degraded mode network module (SAFEDLINK) on X12
7 Connector X1 on the rear of the network module
X3 Connection terminal C-WEB
X13 Plug-type connection for main module
X12 Plug-type connection for degraded mode module
When using shielded cables, the cable screw connections are needed to secure
1
the shielding.
When installing only one network module (SAFEDLINK), ensure that the main
module is installed at the correct position on X13.
X3
1
1
X3
6
X12
A6V10210390_j_en_--
2015-12-15
7