Siemens FS720 Mounting & Installation page 92

Installing, exchanging and connecting modules
6
Install mounting plate
92 | 222
Building Technologies
Fire Safety
10 Threaded holes in rear panel for spacer bolts
11 Fastening clamp, installation position (2 pieces)
12 Spacer bolts, assembled and mounted
13 Fastening clamp (fixed position)
1. Screw the spacers (2) into the threaded hole on the rear panel (1) to the right of
the periphery board.
2. Screw the two spacer bolts (9) into the threaded holes (10) on rear panel to the
left of the periphery board.
3. Screw one counternut (8) onto each spacer bolt (9).
4. Screw the fork heads (7) onto the spacer bolts (9) and fix them in a horizontal
position (in accordance with the figure) using the counternut (8).
5. Insert the mounting plate (4) with the hinge brackets (6) into the fork heads (7)
so that the fastening clamps (11) can be inserted into the fork heads from
above as shown.
6. Swivel the fastening clamps (11) backwards so that they snap in place in the
spacer bolts (9) (see [13] in figure).
7. Swivel the mounting plate (4) over the periphery board and fix it in the spacer
bolts (2) with the fixing screws (3, 5).
8. If the mounting plate is not true, the fork heads can be adjusted with the
counternuts (8) (loosen the fastening clamps and remove the mounting plate).
A6V10210390_j_en_--
2015-12-15