General And Annual Cleaning; Glass Care And Replacement - Jøtul GI 545 DV Installation And Operation Instructions Manual

9.3 Glass Care
Moisture condensation is a normal occurrence with gas
appliances and particulate accumulation may appear
on the inside surface to the glass. Use a dampened, soft
cloth to clean the glass and polish with a dry, soft towel.
Specially-formulated ceramic glass cleaner may also be
used.
DO NOT CLEAN GLASS WHEN IT IS HOT.
!
DO NOT USE ABRASIVE OR AMMONIA-BASED
!
CLEANING SOLUTIONS. TAKE CARE TO NOT SCRATCH THE
GLASS SURFACE.
Glass Replacement
To remove the glass panel or glass gasket:
1. Use the Latch Tool to release the two glass frame
latches on top of the firebox.
2. Swing the top of the glass frame out and lift up to
disengage it from the firebox.
3. Lay the assembly on a flat surface and use a flat blade
screwdriver or pliers to pry up the four steel tabs that
secure the glass panel at the corners of the frame.
4. Install the new glass panel and gasket in the glass
frame and secure with the steel tabs. Do not over-
tighten the tabs as that could break the glass.
ALWAYS USE JØTUL AUTHORIZED PARTS. NEVER SUBSTITUTE
PARTS FROM OTHER SOURCES. See fig. 10.1, page 31.
WARNING:
OBSERVE CAUTION NEAR THE GLASS. THE GLASS
PANEL MAY SHATTER IF STRUCK WITH AN OBJECT.
ALWAYS HANDLE THE GLASS PANEL WITH CARE.
WARNING:
INSPECT THE GLASS SURFACE FOR SCRATCHES AS THESE
CAN WEAKEN THE PANEL TENSILE STRENGTH. REPLACE
THE PANEL IF ANY SCRATCHES ARE EVIDENT. USE ONLY
JOTUL PN 158135. DO NOT SUBSTITUTE ANY OTHER TYPE
OF GLASS.
REPLACEMENT OF THE GLASS SHOULD BE DONE BY A
LICENSED OR QUALIFIED SERVICE PERSON. USE ONLY
REPLACEMENT GLASS PROVIDED BY YOUR AUTHORIZED
JØTUL DEALER. NEVER SUBSTITUTE ANY OTHER
COMPONENTS.
139919 GI 545 DV and DV MV 5/19
Figure 9.1. Gasket application, PN 129124.
Figure 9.2. Glass Replacement. Bend tabs to secure panel.
Use 220042 Tinnerman Clip to replace broken frame tabs.
29