Table of Contents
Advertisement
7.9 Surround Overlay Assembly
Both the Cast Iron and the Steel Surround Overlays are
shipped fully assembled, including the integrated Safety
Barrier Screen.
Installation
The Cast Iron Overlay assembly is heavy - assistance will
be helpful. Handle the enameled assembly carefully to
avoid accidental damage.
The Overlay hanger brackets engage with the inner slots
(C) through the front of the firebox mounting brackets. See
fig. 7.36.
Front Overlay
panel engages
with
INNER SLOTS (C
Figure 7.36 If a Backer Plate is not used, bend the bracket
standoff tabs back to allow air circulation behind the Overlay.
See detail.
C
Bend bracket
stand-off tabs
back 90°
C
139919 GI 545 DV and DV MV 5/19
!
WARNING!
See Fig. 7.36.
• A MINIMUM 1/2"(13 mm) AIR SPACE MUST
BE MAINTAINED BETWEEN THE FRONT
OVERLAY ASSEMBLY AND THE BACKER
PLATE OR FIREPLACE FACE.
THIS AIR SPACE IS AUTOMATICALLY
MAINTAINED BY THE BACKER PLATE
HOOKS WHICH ACT AS STAND-OFFS.
IF A BACKER PLATE IS NOT USED, THE
AIR SPACE MUST BE CREATED BY
BENDING BACK THE TWO STEEL TABS
ON EACH FIREBOX HANGER BRACKET.
SEE DETAIL VIEW BELOW.
• DO NOT MODIFY THE HANGER BRACKET
POSITIONS OR REDUCE THE OVERLAY
AIR SPACE IN ANY WAY. DOING SO MAY
OVERHEAT THE APPLIANCE AND VOID
THE WARRANTY.
Min. 1/2" (13 mm)
air space required
Fireplace face
25
Advertisement
Table of Contents
