Maintenance; General And Annual Cleaning; Accent Lamp Bulb Replacement; Battery Replacement - Jøtul GI 635 DV IPI Installation And Operation Instructions Manual

Maintenance

CAUTION:
THE IGNITION SYSTEM OF THIS APPLIANCE CARRIES
LIVE VOLTAGE. ALWAYS TURN OFF THE GAS SUPPLY
TO THE INSERT AND DISCONNECT THE POWER
SOURCE BEFORE ANY SERVICE WORK IS PERFORMED,
INCLUDING BATTERY REPLACEMENT.
With proper care and maintenance, your appliance will
provide you with years of enjoyment. If you experience
any problem with your fireplace insert, contact your Jøtul
Authorized Dealer for assistance.
KEEP THIS MANUAL FOR REFERENCE AND MAKE IT
AVAILABLE TO ANYONE USING OR SERVICING THE INSERT.
This appliance and venting system should be
inspected before use and at least annually by a qualified
service technician
General Cleaning
• Vacuum the controls area under the firebox at least
monthly or more frequently if pet hair is in the
environment. Always keep the appliance area clear
and free from combustible materials, gasoline and
other flammable liquids. ALWAYS be sure the insert is
cold and NO hot embers or sparks are present before
using a vacuum cleaner.
• The firebox should be vacuumed annually. Inspect
the pilot assembly for corrosion and have any
damaged components replaced by a qualified service
technician. Remove any debris from burner ports,
particularly the pilot carry-over ports. See fig. 54,
page 27. Use a brush attachment to vacuum the log
set.
Gasket Inspection
• Inspect the glass gasket annually. Examine the
gasket for signs of deterioration or stiffness and
confirm that the gasket maintains a positive seal.
This is important to prevent combustion gases
escaping into the room. Replace the gasket if
necessary. Refer to the replacement parts list on
page 43.
Accent Lamp Replacement
1. Remove the cast iron overlay assembly, backer plate,
and glass frame.,
2. Remove the lamp shade and bulb receptacle (three
screws). See fig. 92, pg. 43. Replace with 222943 130V,
50W light bulb.
3. Handle the new bulb with gloves. Skin oils will cause
the bulb to fail prematurely. If you touch the bulb with
your bare skin, wipe it clean with a soft cloth.
4, Replace components previously removed.

Battery Replacement

1. Disconnect electrical power from the appliance.
2. Remove the cast iron overlay.
3. The battery box is attached to the right side controls
compartment by hook and loop tape. Pull the box out
of the compartment and detach the cover plate. Install
four AA batteries noting the polarity indicated on the
box.
4. Replace the battery box and restore AC power to the
fireplace.
CAUTION:
ALWAYS DISCONNECT ELECTRICAL POWER WHEN
SERVICING THIS APPLIANCE.
LABEL ALL WIRES PRIOR TO DISCONNECTION
WHEN SERVICING THE CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND DANGEROUS
OPERATION. ALWAYS VERIFY PROPER OPERATION
AFTER SERVICING THE APPLIANCE.
139712_R00 GI 635 IPI Sept. 2015
37