Firebox Panels - Jøtul GI 545 DV Installation And Operation Instructions Manual

Direct vent fireplace insert
Table of Contents

Advertisement

7.5 Optional Firebox Panels
158113 Black Reflective Glass
• Rear Panel - 226381
• Right Side Panel - 226382
• Left Side Panel - 226383
• Side Panel Stand-off (2) -
226411
• Cotton Gloves
Tools Required:
• Pliers or flat screwdriver
• Safety glasses
These instructions apply to all panel kits, except as noted.
Inspect each panel and contact your dealer if any damage is
found.
THE PANELS ARE VERY FRAGILE. HANDLE GINGERLY.
BE CAREFUL TO AVOID DAMAGE TO EDGES OR CORNERS
BY CONTACT WITH OTHER PARTS OF THE FIREPLACE.
GLASS PANEL NOTES:
USE THE COTTON GLOVES PROVIDED TO HANDLE
THE GLASS PANELS AND PREVENT FINGERPRINT
STAINS. SKIN OIL RESIDUE WILL BE DIFFICULT TO
REMOVE FROM THE GLASS SURFACES.
IMPORTANT!
INSTALL EACH GLASS PANEL ORIENTED WITH THE
TEXTURED SIDE FACING AGAINST THE FIREBOX
WALLS.\
1. Open the Side Panel Retainer Tabs
Panel retainer tabs (fig. 7.8,A) are located at the upper
forward corners of the firebox walls. Use pliers or a
flat head screw driver to bend each retainer out 90°
at the perforation.
2. install the Rear Panel - all kits
• The panel simply rests on the rear burner skirt, flat
against the back of the firebox. The side panels will lock
the rear panel in place as they are installed. Fig. 7.9.
3. Install the Side Panels
• Brick or Fluted Kits
Set each panel on the burner skirt directly against the
firebox wall.
Bend the retainer tabs over the panels just enough to
secure each panel in place.
• Glass Kit only (fig. 7.10)
Set the steel Stand-off Plate (B) on the burner skirt
between the wall and the glass Side Panel (C).
158114 Traditional Red Brick
• Rear Panel - 226403
• Left Side Panel - 226404
• Right Side Panel - 226405
158115 Black Fluted Panels
• Rear Panel - 226395
• Left Side Panel - 226396
• Right Side Panel - 226397
139919 GI 545 DV and DV MV 5/19
Flat Retainer
Tab
A
Figure 7.8
Bend panel
retainer tabs.
Figure 7.9. Install rear panel. Fluted panel shown.
B
Fig. 7.10. Glass panel installation.
BEND TABS ONLY ENOUGH TO KEEP THE PANELS
!
FROM FALLING FORWARD. OVER-BENDING MAY
DAMAGE THE GLASS.
Bent Retainer
Tab
C
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gi 545 dv mv

Table of Contents