Door; Removal; Gasket; Door Handle - Vulcan-Hart C24EA Series Service Manual

REMOVAL

Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1. Close door.
2. Remove COOKING COMPARTMENT LEFT
SIDE PANEL as outlined under Coversand
Panels.
3. Remove nuts from upper hinge located inside
front panel.
Fig. 6
4. Open door slightly, and while holding door, pull
upper hinge away from front panel.
5. Pull upper hinge out of upper door hinge bushing.
6. Lift door assembly up and off lower door hinge.
7. Reassemble parts removed in reverse order.
8. Check door for fit and proper sealing of gasket.

GASKET

Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1. Open door.
2. Remove the shoulder screws and pan pusher
bracket from gasket plate.
F35453 Rev. A (0119)
C24EA SERIES ELECTRIC CONVECTION STEAMERS - DOOR

DOOR

3. Remove gasket plate.
4. Remove gasket from inner door panel.
5. Remove RTV from bottom part of inner door
panel. Apply RTV 109 to bottom of door where
shown when assembling gasket to door.
6. Place a small amount of RTV109 into the inner
door panel gasket screw holes before assembly.
7. Position the new gasket on gasket plate and
reverse procedure to install.
Removal
1. Open door.
Page 10 of 75
Fig. 7
Fig. 8

DOOR HANDLE

Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.