Xfiire Fault Text - Raypak Xfiire 300B Installation And Operation Manual

XFiire Fault Text

Error Display
If there is an active error, then it is displayed in multiple touchscreen views until the error is resolved. For additional error
details please refer to the VERSA IC control manual (5000.72).
Error Item
OUTLET SEN Check the outlet water sensor and its wiring
LIMIT SEN Check the high limit sensor and its wiring
INLET SEN Check the inlet sensor and its wiring
GAS PRESS Check PIM wiring
IGNITION Reset control, push and release RESET button
LIMIT TRIP Heater temperature tripped the high limit
FLAME False flame detected. Shut off gas supply, recycle power
ID CARD Identity card, check ID card and wiring
IGN CTRL Internal control fault. Reset power, replace control
DELTA T Temperature difference between the inlet and outlet exceeded the set point. Check water flow
LOW 24VAC Low 24 VAC power. Check power supply wiring and transformer
BLOW SPEED Blower speed out of range. Check blower wiring and blower
FLOW ERROR The unit is not detecting enough flow to allow ignition sequence to take place
UNDER FLOW The flow reading has drop under minimum requirements to keep the current operation point
FLOW WARNING Operation conditions do not match current flow reading
62
Description and Troubleshooting
Table AD. Error Display