Raymote Troubleshooting - Raypak Xfiire 300B Installation And Operation Manual

2. Note the error code, either through the flash code on
the PIM and/or from the Toolbox menu on the user
interface, and reference the explanation of the fault
along with troubleshooting steps in the XFiire fault
text section.
3. Investigate and correct the cause of the fault.
4. Press and release the RESET key to clear the fault on
the user interface and resume operation. Be sure to
observe the operation of the unit for a period of time
to ensure correct operation and no reoccurrence of
fault code(s).
NOTE: It may be necessary to press RESET buttons
on the specific safety control (eg. optional adjustable
manual reset high limit, low gas pressure switch, high
gas pressure switch, low water cutoff, etc.
A DANGER: When servicing or replacing components
that are in direct contact with the water, be certain that:
• There is no pressure in the heater. (Pull the release
on the relief valve. Do not depend on the pressure
gauge reading).
• The heater water is not hot.
• The electrical power is off.
A WARNING: When servicing or replacing any
components of this unit be certain that:
• The gas is off.
• All electrical power is disconnected.
WARNING: Do not use this appliance if any part has
A
been under water. Improper or dangerous operation may
result. Contact a qualified service technician to inspect
the heater and to repair or replace any part of the heater
that has been under water prior to placing the heater
back in operation.
CAUTION: Wiring errors can cause improper and
A
dangerous operation. Verify proper operation after
servicing. See wiring diagram.
A CAUTION: If overheating occurs or the gas supply
fails to shut off, do not turn off electrical power to the
circulating pump. This may aggravate the problem and
increase the likelihood of heater damage. Instead, shut
off the gas supply to the heater at the gas service valve.
Raymote Troubleshooting Optional
Please refer to the Raymote installation and operation
manual (5000.721).
61