Assembling The Encoder; Assembling The Cover - DURKOPP ADLER 827 Service Instructions Manual

18.3.3 Assembling the encoder

Fig. 67: Assembling the encoder
(1) - Encoder disk
(2) - Encoder
To fit the encoder:
1. Push the encoder (2) and encoder disk (1) onto the shaft.
2. Align the encoder disk (1) so that it runs in the middle of the encoder (2).
3. Tighten the encoder disk (1) and encoder (2) firmly in place.
4. Tighten the retaining plate (3).

18.3.4 Assembling the cover

Fig. 68: Assembling the cover
(1) - Screws
To place the cover:
1. Position the cover (2) at the side.
2. Tighten the screws (1).
84
①
②
③
(3) - Retaining plate
①
②
①
(2) - Cover
Service Instructions 827/827-M - 01.0 - 05/2019
Integrated motor