Table of Contents
Advertisement
Safety Warnings Summary
Copyright © 2018, Juniper Networks, Inc.
Configure the IP address and prefix length for the router management interface.
8.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION:
Although the CLI permits you to configure two management
Ethernet interfaces within the same subnet, only one interface is usable
and supported.
NOTE:
The management ports,
(also labeled
em1
control boards of the PTX10016.
(Optional) Configure the static routes to remote prefixes with access to the
9.
management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain
no-readvertise
Enable Telnet service.
10.
[edit]
root@# set system services telnet
NOTE:
When Telnet is enabled, you cannot log in to a PTX10016 through
Telnet using root credentials. Root login is allowed only for SSH access.
Commit the configuration to activate it on the router.
11.
[edit]
root@# commit
This is a summary of safety warnings.
WARNING:
Failure to observe these safety warnings can result in personal
injury or death.
em0
(
MGMT
for fiber connections) are found on each of the
MGMT
Safety Warnings Summary
for RJ-45 connections) and
31
Advertisement
Table of Contents
