Using With A Battery Pack (Not Supplied) - Sony GV-D200E Operating Instructions Manual

Step 2 Preparing the power supply
Using with a battery pack
(not supplied)
Install the battery pack to use your VCR
outdoors.
Your VCR operates only with the
"InfoLITHIUM" battery pack (L series).
Installing the battery pack
Press and slide the battery pack in the direction
of the arrow.
To remove the battery pack
While pressing BATT, slide the battery pack
to the right.
After installing the battery pack
Do not carry your VCR by holding the battery
pack. If you do so, the battery pack may slide off
and cause damage to your VCR.
Remaining battery time indicator
When you use an InfoLITHIUM battery pack, the
remaining battery time is displayed on the
monitor screen. It may not be displayed properly,
however, depending on the conditions and
circumstances of use. The message appears when
the battery is dead. After you set the POWER
switch to ON, it takes about 1 minute for the
correct remaining battery time to be displayed.
11