Table of Contents
Advertisement
Step 1 Preparing the power supply
Using with a battery pack
(not supplied)
Install the battery pack to use your VCR
outdoors.
You VCR operates only with the "InfoLITHIUM"
battery pack (L series).
Installing the battery pack
Press and slide the battery pack in the direction
of the arrow.
To remove the battery pack
While pressing
BATT, slide the battery pack
to the right.
After installing the battery pack
Do not carry your VCR by holding the battery
pack. If you do so, the battery pack may slide off
and cause damage to your VCR.
Remaining battery time indicator
When you use an InfoLITHIUM battery pack, the
remaining battery time is displayed on the LCD
screen. It may not be displayed properly,
however, depending on the conditions and
circumstances of use. The message appears when
the battery is dead. When you close the LCD
panel and open it again, it takes about 1 minute
for the correct remaining battery time to be
displayed.
Battery Pack (not
supplied)/
9
Advertisement
Table of Contents
