Sony GV-D200E Operating Instructions Manual page 65

Inserting a scene from the other
(playback) VCR – Insert Editing
(1) Set the POWER switch to ON.
(2) On the other (playback) VCR, locate just
before the insert start point [a], then press
PAUSE to set the other (playback) VCR to the
playback pause mode.
(3) On your (recording) VCR, locate the insert
end point [c] by pressing m or M. Then
press X to set your (recording) VCR to the
playback pause mode.
(4) Press ZERO SET MEMORY on the Remote
Commander. The ZERO SET MEMORY
indicator flashes and the end point of the
insert is stored in memory.
The counter shows "0:00:00".
(5) On your (recording) VCR, locate the insert
start point [b] by pressing m, then press
REC and the button on its right
simultaneously to set your (recording) VCR
to the recording pause mode.
(6) First press PAUSE on the other (playback)
VCR, and after a few seconds press X on
your (recording) VCR to start inserting the
new scene.
Inserting automatically stops near the zero
point on the counter. Your (recording) VCR
automatically stops. The end point [c] of the
insert stored in memory is cancelled.
5
REC
To change the insert end point
Press ZERO SET MEMORY again after step 5 to
erase the ZERO SET MEMORY indicator and
begin from step 3.
m
X
m
4
ZERO SET
MEMORY
M
X
0:00:00
ZERO SET
MEMORY
65