Sony GV-D200E Operating Instructions Manual page 61

Dubbing only desired scenes
– Digital program editing
Operation 2: Performing a
Digital program editing
(dubbing a tape)
Make sure both your (playback) VCR and the
other (recording) VCR are connected, and that
the other (recording) VCR is set to recording
pause. When you use the i.LINK cable (DV
connecting cable) the following procedure is not
necessary.
When you use a digital video camera recorder,
set its POWER switch to VCR/VTR.
(1) Select VIDEO EDIT in
settings.
(2) Turn the SEL/PUSH EXEC dial to select
START, then press the dial.
(3) Turn the SEL/PUSH EXEC dial to select
EXECUTE, then press the dial.
Search for the beginning of the first
programme, then start dubbing.
The programme mark flashes.
The SEARCH indicator appears during
search on the monitor screen.
The programme indicator changes to light
blue after the dubbing is complete.
When the dubbing ends, both your (playback)
VCR and the other (recording) VCR
automatically stop.
To stop dubbing
Press x using the video operation buttons.
To end the Digital program editing function
Your (playback) VCR stops when the dubbing is
complete. Then the display returns to VIDEO
EDIT in the menu settings.
Press MENU to end the Digital program editing
function.
You cannot record on the other VCR when
•The cassette is not inserted.
•The tape has run out.
•The write-protect tab is set to expose the red
mark.
•The IR SETUP code is not correct. (When IR is
selected.)
•The button to cancel recording pause is not
correct. (When IR is selected.) (p. 53)
•The programmes to operate the Digital
program editing have not been made.
•i.LINK is selected but the i.LINK cable (DV
connecting cable) is not connected.
•The power of the other (recording) VCR is not
turned on.
in the menu
x
61