Sony DHR-1000 Operating Instructions Manual page 85

Tip
During recording, the
indicators light according to
the audio mode and the
track being recorded.
Example: when sound is
recorded onto the stereo 1
track in 12-bit audio.
Note
Depending on the VCR,
when you playback mixed
sound (stereo 1 track and
stereo 2 track), the volume
of stereo 1 track may change
depending on whether
sound is recorded on stereo
2 track or not.
5
Locate the playback start point of the source tape (C),
then set the VCR to playback pause.
For best results, pause the tape a few seconds before the
beginning of the scene.
6
Press the pause button on the other VCR to start
playback. At the beginning of the scene you want to
replace, press P PAUSE on this VCR to start recording.
Audio insert editing starts.
When the tape counter reaches "0H00M00S", the recording tape
stops automatically.
7
Press p STOP on the other VCR.
How the audio recording mode selection affects editing results
When you record from DV input
This VCR automatically records in the same audio mode as the source
tape, regardless of the LINE IN AUDIO setting in the ADVANCED
OPTIONS menu. For this connection, press both the STEREO 1 INSERT
and STEREO 2 INSERT buttons.
When you record from LINE inputs
The sound is recorded in the audio mode selected in LINE IN AUDIO in
the ADVANCED OPTIONS menu. Normally, choose the original audio
mode of the tape to be edited. Select the track to be replaced according
to the audio recording mode.
Original audio Menu
mode of the choice
edited tape
12-bit 12-bit
16-bit
16-bit 12-bit
16-bit
*Insert editing cannot be executed if you press only one
button.
Pressed Editing result
button(s)
: Replaced section
STEREO 1
Stereo1
Stereo2
STEREO 2
Stereo1
Stereo2
STEREO 1 and
Stereo1
STEREO 2
Stereo2
STEREO 1 and
Stereo1
STEREO 2*
Stereo2
STEREO 1 and
STEREO 2*
STEREO 1 and
STEREO 2*
NO AUDIO
(Deleted)
NO AUDIO
(Deleted)
85
Editing