Video Insert Editing - Sony DHR-1000 Operating Instructions Manual

Editing with LANC cable

Video insert editing

Notes
• Do not change the counter
display during insert
editing. Editing may not
function accurately.
• Insert editing cannot be
made on a blank portion of
the tape. When a blank is
detected, the VCR stops
editing.
• If you record on the
beginning part of the tape,
or on the part just after the
unrecorded portion, the
first part of recording may
be dropped.
You can replace the original picture with a scene from the source tape,
while retaining the original sound.
Before you start editing, set up the system according to the instructions
on pages 64 to 66.
For video insert editing, use the tape recorded by this VCR. If you want
to edit the one recorded by other VCRs (include other DHR-1000s), first,
you have to dub it to the tape on this VCR, then edit it. If you edit the
tape recorded by the other VCRs, the sound quality may be reduced
and the picture may be noisy.
COUNTER
RESET
COUNTER
SELECT
Source tape
Edited tape
1
Press COUNTER SELECT so that the
tape counter appears.
2
Locate the end point (A) of the
scene to be recorded over.
1 Press RECORDER.
2 Press ( (PLAY), then locate the
recording end point with the jog dial
or shuttle ring.
3 Press COUNTER RESET.
VIDEO INSERT
EDIT STANDBY
START/PAUSE
C
Replaced video section
B A
( (PLAY)
p (STOP)
PLAYER
RECORDER
Shuttle ring/
Jog dial
(continued)
73
Editing