2. Connection and Installation
2.1 Hard Disk Installation
You can install up to four 3.5" HDDs. The maximum capacity of each HDD is 8TB.
1. Make sure the DVR is power-off. Unscrew the ten housing screws on the DVR, and remove
the housing cover from the DVR.
2. Find the SATA cable inside the DVR, and connect the SATA cable to the SATA port on the HDD
(left image). Find the internal power cable, and connect the internal power cable to the HDD
(right image).
3. Place the HDDs inside the DVR, screw the HDDs from the bottom side of the DVR using the
supplied Screws. After installing the HDDs, screw the housing cover back to the DVR.
H.265 VANGUARD 16x8H Plus
5
Chapter
2