General Setup Menu - Sony PCS-G70 Operating Instructions Manual

Monitor Out
Monitor Out
Monitors
VIDEO1
Connection
Main
Monitor
Monitors
Allows you to specify the number of
monitors connected to the system.
1: One monitor connected.
2: Two monitors connected.
3: Three monitors connected.
Connection
Select the connector(s) used to connect the
monitor(s).
VIDEO 1: Select when the monitor is
connected to the VIDEO 1 connector.
VIDEO 2: Select when the monitor is
connected to the VIDEO 2 connector.
RGB OUT: Select when the monitor is
connected to the RGB OUT connector of
the main unit.
RGB OUT (DSB): Select when the monitor
is connected to the RGB OUT connector
of the Data Solution Box.
Monitor
Select whether to use the connected monitor
as the sub- or main monitor.
Main: The connected monitor is used as the
main monitor.
Sub: The connected monitor is used as a
sub-monitor.
1
VIDEO2 RGB OUT RGB OUT(DSB)
Sub Sub
Save Cancel

General Setup Menu

The following menus appear when you
select "General" on the Setup menu for
the administrator. Select the desired
menu.
General Setup
Device Setup Page 1/2
General
Device Setup
Page: 1/2
Clock Set
Terminal Name
Standby Mode
Standby Time
Last Number Registration
Control by Far End
Clock Set
Enter the current date and time.
Terminal Name
Input the terminal name to report when the
system is connected to the remote system.
Standby Mode
Allows you to select whether the
Communication Terminal enters standby
mode if idle for a specified period of time.
On: Allows the system to go on standby.
Off: Does not allow the system to go on
standby.
Standby Time
Specify the time the system must remain idle
before entering the standby mode. This time
can be between 1 and 99 minutes.
Registering Local Information
Device Setup
Menu Screens
Whiteboard
Launcher
Cancel
MM/DD/YYYY HH:MM:SS
11/30/2003 19:25:53
Off
On
On
Save Cancel
53