Camera Setup Menu; General Setup Menu - Sony PCS-XG80 Operating Instructions Manual

Color
Allows you to select the color of the letters
or graphics written on the screen with a pen
tablet.
You can select from among "Black", "Red",
"Blue", "Green", "Yellow", "Orange",
"Purple" and "White".
Line Density
Allows you to select the density of the line
written on the screen with a pen tablet.
You can select from among "Thick",
"Medium" and "Narrow".

Camera Setup Menu

Camera
Camera
Fade In
Allows you to select whether to use the fade-
in function when the camera moves to the
preset position. The picture in the preset
position fades in on a monitor screen.
On: Enables the fade-in function.
Off: Disables the fade-in function.
Second Camera Input
Allows you to select the input connector on
the Communication System to which the
second camera is connected.
RGB: Connects the second camera to the
RGB IN connector.
YPbPr: Connects the second camera to the
VIDEO IN YPbPr jacks.
S-VIDEO: Connects the second camera to
the S VIDEO IN connector.
Image Flip for First Camera
Allows you to select whether to rotate the
camera image 180 degrees when the first
camera is installed on a ceiling.
Flip Vertical: Rotates the image 180
degrees.
Off: Does not rotate the image 180 degrees.
Image Flip for Second Camera
Allows you to select whether to rotate the
camera image 180 degrees when the second
camera is installed on a ceiling.
Flip Vertical: Rotates the image 180
degrees.
80
Registering Local Information
Off: Does not rotate the image 180 degrees.
Note
The "Image Flip" function will be enabled after
system rebooting.

General Setup Menu

General1
Device Setup
Terminal Name
Input the local terminal name transmitted to
a remote party (up to 30 characters).
Standby Mode
Allows you to select whether the
Communication System enters standby
mode if it is idle for a specified period of
time.
On: Allows the System to go on standby.
Off: Does not allow the System to go on
standby.
Standby Time
Specify the time the system must remain idle
before entering the standby mode. This time
can be set between 1 and 99 minutes.
For details on the standby mode, see
"Standby Mode Function" on page 41.
Last Number Registration
Allows you to select whether to register the
remote party in the Phone Book after the
communication ends.
Off: The registration of the remote party
does not take place.
On: If the remote party is not registered in
the Phone Book, the message "Register
this participant in the list?" appears on
the monitor screen when communication
ends. When you select "OK", the List
Edit menu opens.
Control by Far End
When "Far End Camera Control" is set to
"On" in the Communication setup menu,
you can temporarily reject the camera
control command transmitted by the remote
party.
On: Accepts the camera control command.