Enabling The Edge Cutter With A Dac Mini; Buttons On The Machine Arm - DURKOPP ADLER 275 Series Operating Instructions Manual

46

4.12.3 Enabling the edge cutter with a DAC mini

The edge cutter must be enabled via the DAC mini for every
sequence in which it is to work
To enable the edge cutter with a DAC mini:
1. Press the F button on the DAC mini control panel.
 The green LED above the F button lights up.
The edge cutter is enabled.

4.13 Buttons on the machine arm

A keypad is located on the machine arm, which is equipped with
different buttons depending on the subclass and installed equip-
ment.
Fig. 26: Buttons on the machinearm
(1) - Additional equipment
Element Function/Meaning
Bartack toggle
When bartacking is generally switched on then this but-
ton switches off the next bartack.
When bartacking is generally switched off then this but-
ton switches on the next bartack.
Setting the needle to the high/low positions
The procedure for setting the position is described in
the control.
(
p. 92).
Operating Instructions 275 - 02.0 - 08/2019
Operation
①