DURKOPP ADLER 275 Series Operating Instructions Manual page 96

94
Moving to the reference position after every thread-cutting
operation
After switching on the machine the stepper motor for setting the
length of the upper transport moves to the reference position once.
To allow the position of the stepper motor to be checked more
frequently, the stepper motor can also be moved to the reference
position after every thread-cutting operation.
To move to the reference position after every thread-cutting ope-
ration:
1. After calling up the special functions, press sequence button 4.
 The display (3) shows the Reference
selection:
2. Change the setting using the buttons
• Move the machine to the reference position only at
switch-on: Set the display to 00.
• Move the machine to the reference position after every
thread cutting operation: Set the display to 01.
Information
The machine is set to 00 when delivered.
3. Save the desired Setting by pressing the button
 The LED above the button goes out.
The system switches out of the special function mode back
into normal operation.
Operating Instructions 275 - 02.0 - 08/2019
Setup
.
twice.